translate

RC Wings
 
Electronic speed controllers
  • ESC 14s 250A

    ESC brushless controller.

    14s

    250A

    € 359,95 € 434,95
  • ESC 12s 140A

    ESC brushless controller.

    12s

    140A

    € 199,95 € 249,95
  • ESC 12s 100A

    brushless speed controler

    12s lipo

    100A

    € 169,95 € 199,95
  • ESC 30-35 AMP

    2-3 CELL LIPO

    € 30,00
  • 8 S Castle Creations Phoenix Edge 75

    SPECIFICATIONS

    Input Voltage: 2S-8S LiPo
    Max Continuous Amps at Full Throttle: 75
    Dimensions: 2.0 x 2.8 x 0.9" (50.8 x 71.9 x 23.2mm)
    Weight: 4.0oz (113.4g) with wires
    2.5oz (70.9g) without wires

    € 123,99
  • 12 S -PHX EDGE 80 HV WITH CC BEC PRO

     

    Telemetry Capable : Yes
    ESC Current Rating : 80
    Data Logging : Yes
    Auxiliary Wire : Yes
    Internal BEC : No
    Minimum Input Voltage : 3S
    Maximum Input Voltage : 12S

     

    € 199,99
  • 8 S-Castle Creations Castle Phoenix Edge 100

    Technical Specs


    Input voltage: MIN: 2S LiPo MAX: 8S LiPo
    Max continuous amperage at full throttle: 100 amps*
    BEC voltage (voltage regulator for powering radio and sevos): User selectable choice from 5 to 8.4 volt output
    BEC output amperage: 5 amp peak**

    Size and Weight
    Width: 2.0" (50.8mm)
    Length: 2.8" (71.9mm)
    Height: 0.9" (23.2mm)
    Weight w/wires: 4.5 oz (126.6g)
    Weight w/o wires: 2.6 oz (72.9g)

    € 139,99
  • 12 S-PHX EDGE 120 HV AND CC BEC PRO

     Phoenix Edge HV 120

    Telemetry Capable : Yes
    ESC Current Rating : 120
    Data Logging : Yes
    Auxiliary Wire : Yes
    Internal BEC : No
    Minimum Input Voltage : 3S
    Maximum Input Voltage : 12S

     

    € 279,99
  • 12 S-PHX EDGE 160 HV WITH CC BEC PRO

     Castle Creations Edge HV 160

    Telemetry Capable : Yes
    ESC Current Rating : 160
    Data Logging : Yes
    Auxiliary Wire : Yes
    Internal BEC : No
    Minimum Input Voltage : 3S
    Maximum Input Voltage : 12S

     

    € 349,99
  • 6 S-80-Amp Pro Switch-Mode BEC Brushless ESC, EC5 (V2)

    Key Features

    Up to 80 amps continuous current with proper air flow and 100 amps burst current (15 seconds)
    5V switch-mode BEC capable of 5 amps continuous current with 6 amps max burst on any recommended input voltage
    Drive up to 7 analog or 6 digital standard-size servos with the BEC on any recommended input voltage
    3- to 6-cell Li-Po, 9- to 18-cell Ni-MH/Ni-Cd input voltage
    Programmable motor braking
    Safe power-arm mode prevents accidental starts
    Programmable low voltage cutoff with settings for 3-cell Li-Po (9.2V), 4-cell Li-Po (12V), 5-cell Li-Po (15V), 6-cell Li-Po (18V) or 74% of battery starting voltage
    Programmable throttle input range (1.1ms–1.9ms or 1.2ms–1.8ms)
    Programmable soft start-up rate - .25 second or 1 second
    Auto motor shut down if signal is lost or there is interference
    Programmable timing—5 user-selectable ranges–use with a large variety of brushless motors
    Two operating modes–Airplane or Heli
    Pre-wired connectors—E-flite EC5 on battery input and 4.0mm female gold bullets on motor output leads
    NOTE: Not recommended to use with E-flite Power 60 Brushless Outrunner (EFLM4060A)

    Overview

    When performance matters in your high-current applications, look no further than the E-flite® 80-amp Pro switch-mode ESC. This is a high-quality, efficient sensorless brushless electronic speed control with an integrated switch-mode BEC. It can operate without the need for a separate receiver battery to power your servos and receivers, saving you weight and complication. It is capable of up to 80 amps continuous current when using 3- to 6-series Li-Po battery packs. You can drive up to 7 analog or 6 digital standard-size servos with the BEC on any recommended input voltage. Featuring an exposed, finned heat sink aluminum case with lightweight plastic end-caps, safe power-arming along with advanced programmable features such as low voltage cutoff, braking, timing, throttle input range and more, the E-flite 80-amp Pro switch-mode ESC is truly a ‘pro series’ electronic speed control.

    This product is not intended for use by children under 14 years of age without direct adult supervision.

    € 115,99
  • 6 S-60-Amp Pro Switch-Mode BEC Brushless ESC (V2)

    Key Features

    Up to 60 amps continuous current with proper air flow and 75 amps burst current (15 seconds)
    5A continuous current, 5V switch-mode BEC circuit (proper cooling and airflow required)
    Stronger BEC for support of most 3-axis stabilization systems
    Drive up to 7 analog or 6 digital standard-sized servos with the BEC on any recommended input voltage
    3- to 6-cell Li-Po, 9- to 18-cell Ni-MH/Ni-Cd input voltage
    Finned heat sinks
    Programmable motor braking
    Safe power-arm mode prevents accidental starts
    Programmable low voltage cutoff with settings for 3-cell Li-Po (9V), 4-cell Li-Po (12V), 5-cell Li-Po (15V), 6-cell Li-Po (18V) or 74% of battery starting voltage
    Programmable throttle input range (1.1ms–1.9ms or 1.2ms–1.8ms)
    Programmable soft start for helis and airplanes
    Auto motor shut down if signal is lost or there is interference
    Programmable timing—5 user-selectable ranges for use with a large variety of brushless motors
    Utilizes new smaller MOSFET technology to minimize weight
    Radio system power on/off switch
    Pre-wired connectors—E-flite® EC3™ connector on battery input and 3.5mm gold bullet connectors on motor output leads

    Overview
    The E-flite® 60-Amp Pro Switch-Mode BEC Brushless ESC (V2). This is a high-quality sensorless brushless electronic speed control with an integrated switch-mode BEC that is very lightweight and efficient. It can operate without the need for a separate receiver battery to power your servos and receivers, saving you weight and complication.

    € 97,99
  • 6 S-40-Amp Pro Switch-Mode BEC Brushless ESC (V2)

    Key Features

    Up to 40 amps continuous current with proper air flow and 55 amps burst current (15 seconds)
    5A continuous current, 5V Switch-Mode BEC Circuit (Proper cooling and airflow required)
    Stronger BEC for support of most 3-axis stabilization systems
    Drive up to 7 analog or 6 digital standard-sized servos with the BEC
    3- to 6-cell Li-Po, 9- to 18-cell Ni-MH/Ni-Cd input voltage
    Finned heat sinks
    Programmable motor braking
    Safe power-arm mode prevents accidental starts
    Programmable low voltage cutoff with settings for 3-cell Li-Po (9V), 4-cell Li-Po (12V), 5-cell Li-Po (15V), 6-cell Li-Po (18V) or 70% of battery starting voltage
    Programmable throttle input range
    Programmable soft start for helis and airplanes
    Auto motor shut down if signal is lost or there is interference
    Programmable timing—5 user-selectable ranges to use with a large variety of brushless motors
    Utilizes new smaller Mosfet technology to minimize weight
    Radio System Power ON /OFF Switch
    Prewired connectors—E-flite EC3™ connector on battery input and 3.5mm gold bullet connectors on motor output leads

    Overview
    E-flite® 40-Amp Pro Switch-Mode BEC Brushless ESC (V2) is a high-quality sensorless brushless electronic speed control with an integrated switch-mode BEC that is very lightweight and efficient. It can operate without the need for a separate receiver battery to power your servos and receivers, saving you weight and complication.

    € 73,99
  • 4 S-30-Amp Pro Switch-Mode BEC Brushless ESC (V2)

    Key Features

    Up to 30 amps continuous current with proper air flow and 35 amps burst current (15 seconds)
    3.5A continuous current, 5V Switch-Mode BEC Circuit
    Stronger BEC for support of most 3-axis stabilization systems
    Drive up to 7 analog or 6 digital standard-size servos with the BEC
    3- to 4-cell Li-Po, 9- to 12-cell Ni-MH/Ni-Cd input voltage
    Programmable motor braking
    Safe power-arm mode prevents accidental starts
    Programmable low voltage cutoff with settings for 3-cell Li-Po (9.2V), 4-cell Li-Po (12V) or 74% of battery starting voltage
    Programmable throttle input range (1.1ms–1.9ms or 1.2ms–1.8ms)
    Programmable soft start for helis and airplanes
    Auto motor shut down if signal is lost or there is interference
    Programmable timing—5 user-selectable ranges for use with a large variety of brushless motors
    Pre-wired connectors—E-flite EC3™ connector on battery input and 3.5mm gold bullet connectors on motor output leads

    Overview
    The E-flite® 30-Amp Pro Switch-mode BEC Brushless ESC (V2). This is a high-quality sensorless brushless electronic speed control with an integrated switch-mode BEC that is very lightweight and efficient. It can operate without the need for a separate receiver battery to power your servos and receivers, saving you weight and complication.

    € 50,99
  • REGELAAR 25 900

    Esc 25 Amp Whit water cooling

    € 22,70 € 36,30
  • PILOT 8 2-3 S LIPO

    2 / 3 S LIPO

    € 26,34 € 42,10
  • SOFT SWITCH 20

    4,8-8,4/20 A

    € 17,10 € 27,30
  • BRUSHLESS ESC 30 AMP

    2-3 S Lipo 30 Amp

    € 22,49
  • SPITZ GYRO

    SPITZ GYRO + HEADING LOCK

    € 19,99 € 56,00
  • REGULATOR C35 WITH CARD (85520)

    Electronic Speed Controller C35 met card (85520)

    € 30,50 € 44,50
  • REGULATOR 45 WITH CARD (85520)

    Electronic Speed Controller 45 opto

    .2-6 S LiPo

    € 37,50 € 60,00